LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2368 (Engine Ignition System - 3.0L) >> Removal And Installation >> Ignition Coil-On-Plug >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

RH side 

  1. NOTE: The upper intake manifold must be removed to access the RH ignition coil-on-plugs only.

    Remove the upper intake manifold. For additional information, refer to ENGINE - 3.0L (4V) .

    Both sides 

  2. Disconnect the 6 ignition coil-on-plug electrical connectors.
  3. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.

    Remove the 6 bolts and the 6 ignition coil-on-plugs.

    • To install, tighten to 7 Nm (62 lb-in).
  4. To install, reverse the removal procedure.
    • Apply a small amount of dielectric grease to the inside of the ignition coil-on-plug boots before attaching to the spark plugs.
scientia non olet · About LEMON Manuals