Symptom Table - NVH

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: NVH symptoms should be identified using the diagnostic tools that are available. For a list of these tools, an explanation of their uses and a glossary of common terms, refer to GLOSSARY OF TERMS . Since it is possible any one of multiple systems may be the cause of a symptom, it may be necessary to use a process of elimination type of diagnostic approach to pinpoint the responsible system. If this is not the causal system for the symptom, refer back to NOISE, VIBRATION AND HARSHNESS (NVH) for the next likely system and continue diagnosis.

SYMPTOM TABLE - NVH

Condition	Possible Sources	Action
Vibration - a high frequency (20-80 Hz) vibration that is felt through the seat or the selector lever. Changes with engine speed	Selector lever cable incorrectly routed, grounded out or loose	REFER to SELECTOR LEVER CABLE .
-	Loose selector lever cable bracket	CHECK the selector lever cable and bracket for damage and correct assembly. REFER to SELECTOR LEVER CABLE . REPAIR as necessary.
Rattle, noise, buzz or other noise	Selector lever loose Noisy selector lever	TIGHTEN the selector lever nuts. INSTALL a new selector lever. REFER to Installation .