LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2356 (Automatic Transaxle External Controls AISIN Aw21/6F35 (Except Hybrid)) >> General Procedures >> Selector Lever Knob >> Installation

Selector Lever Knob: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. Install the selector lever knob on the selector lever and install the screws.
    NOTE: For vehicles equipped with a 2.5L engine, it is necessary to route the Transmission Control Switch (TCS) harness through the selector lever bezel when installing the selector lever knob.
    NOTE: Fusion/Milan shown in illustration, MKZ similar.
    Fig 1: Locating Selector Lever Knob & Bezel
    G06275704Courtesy of FORD MOTOR CO.
  2. Slide the selector lever knob bezel up and install it on the selector lever knob.
    NOTE: Fusion/Milan shown in illustration, MKZ similar.
    Fig 2: Sliding Selector Lever Knob Bezel Up
    G06275711Courtesy of FORD MOTOR CO.

    Vehicles equipped with 2.5L engine 

  3. Connect the TCS electrical connector.
    Fig 3: Locating TCS Electrical Connector
    G06275702Courtesy of FORD MOTOR CO.
  4. Install the center console trim panel.
    Fig 4: Locating Center Console Trim Panel
    G06275642Courtesy of FORD MOTOR CO.
  5. Install the selector lever trim ring.
Fig 5: Locating Selector Lever Trim Ring
G06275641Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals