LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2356 (Automatic Transaxle External Controls AISIN Aw21/6F35 (Except Hybrid)) >> General Procedures >> Selector Lever Cable >> Removal

Selector Lever Cable: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the heater core and evaporator core housing. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Remove the Restraints Control Module (RCM). For additional information, refer to REMOVAL .
  3. Remove the battery tray. For additional information, refer to REMOVAL AND INSTALLATION .
  4. Disconnect the selector lever cable end from the manual control lever.
    NOTE: Aisin AW21 shown in illustration, 6F35 similar.
    Fig 1: Locating Selector Lever Cable
    G06275663Courtesy of FORD MOTOR CO.
  5. Release the 2 tabs and remove the selector lever cable from the selector lever cable bracket.
    NOTE: Aisin AW21 shown in illustration, 6F35 similar.
    Fig 2: Locating Selector Lever Cable Tabs
    G06275664Courtesy of FORD MOTOR CO.
  6. Disconnect the 2 wiring harness fasteners and position the RCM  wiring harness aside.
    Fig 3: Locating Wiring Harness Fasteners
    G06275665Courtesy of FORD MOTOR CO.
  7. Position the insulation blanket away from the bulkhead to gain access to the 2 selector lever cable bracket nuts.
    Fig 4: Positioning Insulation Blanket Away From Bulkhead To Gain Access
    G06275666Courtesy of FORD MOTOR CO.
  8. Remove the 2 selector lever cable grommet nuts and remove the selector lever cable through the interior of the vehicle.
    Fig 5: Locating Selector Lever Cable Grommet Nuts
    G06275667Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals