LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2356 (Automatic Transaxle External Controls AISIN Aw21/6F35 (Except Hybrid)) >> General Procedures >> Selector Lever Cable Adjustment - Aisin AW21

Selector Lever Cable Adjustment - Aisin AW21

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Air Cleaner (ACL) assembly. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Disconnect the selector lever cable end from the manual control lever.
    Fig 1: Locating Selector Lever Cable
    G06275649Courtesy of FORD MOTOR CO.
  3. Place the selector lever in DRIVE.
    Fig 2: Identifying Selector Lever In DRIVE Position
    G06275650Courtesy of FORD MOTOR CO.
  4. Place the manual control lever in DRIVE.
    1. Place the manual control lever in PARK.
    2. Move the manual control lever counterclockwise 3 detents to the DRIVE position.
    Fig 3: Identifying Manual Control Lever In PARK Position
    G06275651Courtesy of FORD MOTOR CO.
  5. Release the selector lever cable adjuster lock.
    1. Pull out on the adjuster lock tabs.
    2. Slide the lock up to unlock the selector lever cable.
    Fig 4: Releasing Selector Lever Cable Adjuster Lock
    G06275652Courtesy of FORD MOTOR CO.
  6. Align the selector lever cable end to the manual control lever ball stud and install it with the adjuster unlocked.
    Fig 5: Aligning Selector Lever Cable End To Manual Control Lever Ball Stud
    G06275653Courtesy of FORD MOTOR CO.
  7. Slide the adjuster tab in place to lock the selector lever cable.
    Fig 6: Sliding Adjuster Tab
    G06275654Courtesy of FORD MOTOR CO.
  8. Install the ACL  assembly. For additional information, refer to REMOVAL AND INSTALLATION .
  9. Verify that the vehicle starts in PARK and NEUTRAL only and that the reverse lamps illuminate in REVERSE.