LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2356 (Automatic Transaxle External Controls AISIN Aw21/6F35 (Except Hybrid)) >> General Procedures >> Selector Lever Bezel - Fusion/Milan >> Installation

Selector Lever Bezel - Fusion/Milan: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Vehicles equipped with a 2.5L engine 

  1. Install the selector lever bezel on the selector lever.
    • Position the override lever in the override lever guide.
    • Make sure that the 3 locking tabs are locked in place.
    NOTE: Be sure that the override lever is inserted in the override lever guide or the shift interlock override button will not work correctly.
    NOTE: Selector lever removed for clarity.
    Fig 1: Positioning Override Lever In Override Lever Guide
    G06275707Courtesy of FORD MOTOR CO.

    Vehicles equipped with a 3.0L or 3.5L engine 

  2. Install the selector lever bezel on the selector lever and be sure the 3 tabs are locked in place.
    NOTE: Selector lever removed for clarity.
    Fig 2: Locating Selector Lever Knob Bezel Tabs
    G06275706Courtesy of FORD MOTOR CO.

    All vehicles 

  3. Connect the selector lever bezel electrical connector.
    Fig 3: Locating Selector Lever Bezel Electrical Connector
    G06275705Courtesy of FORD MOTOR CO.
  4. Install the selector lever knob on the selector lever and install the screws.
    NOTE: For vehicles equipped with a 2.5L engine, it is necessary to route the Transmission Control Switch (TCS) harness through the selector lever bezel when installing the selector lever knob.
    Fig 4: Locating Selector Lever Knob & Bezel
    G06275704Courtesy of FORD MOTOR CO.
  5. Slide the selector lever knob bezel up and install it on the selector lever knob.
    Fig 5: Sliding Selector Lever Knob Bezel Up
    G06275711Courtesy of FORD MOTOR CO.

    Vehicles equipped with 2.5L engine 

  6. Connect the TCS electrical connector.
    Fig 6: Locating Transmission Control Switch Electrical Connector
    G06275702Courtesy of FORD MOTOR CO.

    All vehicles 

  7. Position the utility tray in place and connect the electrical connector.
    Fig 7: Locating Electrical Connector
    G06275701Courtesy of FORD MOTOR CO.
  8. Install the utility tray on the center console.
    Fig 8: Locating Utility Tray
    G06275700Courtesy of FORD MOTOR CO.
  9. Install the center console trim panel.
    Fig 9: Locating Center Console Trim Panel
    G06275642Courtesy of FORD MOTOR CO.
  10. Install the selector lever trim ring.
Fig 10: Locating Selector Lever Trim Ring
G06275641Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals