LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2356 (Automatic Transaxle External Controls AISIN Aw21/6F35 (Except Hybrid)) >> General Procedures >> Selector Lever - Fusion/Milan >> Removal

Selector Lever - Fusion/Milan: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the center console. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Disconnect the selector lever cable end from the selector lever.
    Fig 1: Locating Selector Lever Cable
    G06275674Courtesy of FORD MOTOR CO.
  3. Release the tab on the selector lever cable and remove it from the selector lever housing.
    Fig 2: Locating Selector Lever Cable Tab
    G06275675Courtesy of FORD MOTOR CO.
  4. Disconnect the electrical connector.
    Fig 3: Locating Electrical Connector
    G06275676Courtesy of FORD MOTOR CO.
  5. Remove the 4 nuts and remove the selector lever.
    Fig 4: Locating Selector Lever Nuts
    G06275677Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals