Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the RH front fender splash shield. For additional information, refer to REMOVAL AND INSTALLATION .
Remove the windshield washer pump.
1. Disconnect the electrical connector.
2. Disconnect the hoses.
3. Remove the windshield washer pump.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

NOTE: When installing the windshield washer pump, be careful not to damage the rubber grommet.

NOTE: To prevent spilling windshield washer fluid, drain the windshield washer reservoir before washer pump removal.

Fig 1: Identifying Windshield Washer Pump, Hoses & Electrical Connector
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Fill the windshield washer reservoir with windshield washer fluid.
NOTE: Do not operate the windshield washer pump prior to filling the windshield washer reservoir. Failure to follow these instructions may result in premature pump failure.