Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rain sensor cover.
- Pull the rain sensor cover outward off the windshield.
Disconnect the rain sensor electrical connector.

Fig 1: Locating Rain Sensor Electrical Connector
Courtesy of FORD MOTOR CO.
Using a flat-blade screwdriver, release the 2 rain sensor retaining clips from the windshield mounted bracket and remove the rain sensor.
NOTE: Lightly press the rain sensor against the glass to relieve clip tension.

Fig 2: Removing Rain Sensor
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.

Make sure to align the rain sensor alignment tab to the alignment slot on the rain sensor mount.