LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2354 (Wiper System & Washer System) >> Diagnosis And Testing >> Wipers and Washers >> Pinpoint Tests >> Pinpoint Test G: The Headlamps Do Not Illuminate When the Wipers are On >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

The Smart Junction Box (SJB) sends a 12 volt reference signal on circuit CRW01 (WH) to the wiper motor module in order to monitor the status of the wipers. When the headlamp control switch is in the AUTOLAMP position and the wipers are on, the wiper motor module will pull the voltage reference signal low. After 3 seconds, the SJB  will activate the headlamps.

This pinpoint test is intended to diagnose the following: 

scientia non olet · About LEMON Manuals