LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2353 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Rear Door Latch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door window regulator and motor. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Remove the exterior door handle. For additional information, refer to Removal and Installation .
  3. Position the rear door window glass at the top of the door.
  4. Loosen the exterior door handle reinforcement bolt.
    • To install, tighten to 6 Nm (53 lb-in).
    Fig 1: Locating Exterior Door Handle Reinforcement Bolt
    G06259749Courtesy of FORD MOTOR CO.
  5. Slide the exterior rear door handle reinforcement to the front of the vehicle and push inside the door.
  6. Remove the 3 rear door latch bolts.
    • To install, tighten to 8 Nm (71 lb-in).
  7. Remove the complete latch, carrier, and handle reinforcement assembly from the door.
  8. Open the clip and disconnect the exterior rear door handle actuating rod.
  9. Remove the 2 screws and remove the rear door latch from the carrier.
  10. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals