LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2353 (Handles, Locks, Latches And Entry Systems) >> General Procedures >> Latch Lubrication >> Material

Latch Lubrication: Material

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
MATERIAL SPECIFICATIONS TABLE

Item Specification
Multi-Purpose Grease XG-4 and/or XL-5 ESB-M1C93-B
  1. Open the door.
  2. Using a screwdriver, fully close the latch (2 clicks).
    Fig 1: Closing Latch Using Screwdriver
    G06071166Courtesy of FORD MOTOR CO.
  3. Spray the multi-purpose grease into the opening on the door latch for approximately 5 seconds.
    Fig 2: Spraying Multi-Purpose Grease Into Opening On Door Latch
    G06077610Courtesy of FORD MOTOR CO.
  4. Open the latch using either the interior or exterior door handle.
  5. Open and close the door several times to circulate the lubricant inside the latch.
  6. Wipe off any excess grease.
scientia non olet · About LEMON Manuals