LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2352 (Steering Column) >> Removal And Installation >> Steering Wheel Bezel >> Installation

Steering Wheel Bezel: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Carefully install the bezel onto the steering wheel as instructed or damage to the bezel can occur.
  1. Position the bezel onto the steering wheel and align the 10 pins with their respective holes.
  2. Beginning with the upper RH corner and continuing in a clockwise direction, push the bezel onto the steering wheel until the pins are seated approximately half-way into the holes.
    NOTE: The bezel is installed in 2 stages. Stage 1 seats the 10 pins into the steering wheel approximately half-way. Stage 2 fully seats the 10 pins into the steering wheel.
  3. Beginning with the upper RH corner and continuing in a clockwise direction, push the bezel onto the steering wheel until the pins are fully seated into the holes.
  4. Install the driver air bag module. For additional information, refer to INSTALLATION .
scientia non olet · About LEMON Manuals