LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2351 (Seat System - Seats) >> Removal And Installation >> Seat Cushion Cover - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat backrest. For additional information, refer to SEAT BACKREST - FRONT, WITHOUT FOLD FLAT  or SEAT BACKREST - FRONT, WITH FOLD FLAT .
  2. Release all the remaining J-clips attaching the trim cover to the cushion frame.
    NOTE: Trim cover J-clip configurations vary with seat option.
  3. Release the hook-and-loop strips, remove the hog rings (if equipped), separate the cushion trim cover from the cushion foam pad and remove.
    NOTE: Use care when separating the seat cushion trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the cushion foam pad.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals