Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Motorcraft® Electric A/C Compressor Oil only must be used as a refrigerant system lubricant for hybrid vehicles. Addition of any oil other than Motorcraft® Electric A/C Compressor Oil to the hybrid vehicle refrigerant system will damage the electric Air Conditioning (A/C) compressor and contaminate the refrigerant system. Refer to REFRIGERANT OIL ADDING procedure.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Recover the refrigerant. For additional information, refer to REFRIGERANT SYSTEM RECOVERY .
Disconnect the condenser inlet fitting nut and disconnect the fitting.
- Discard the gasket seal.
- To install, tighten to 15 Nm (133 lb-in).
Remove the lower rear A/C compressor bolt.
- To install, tighten to 25 Nm (18 lb-ft).
Remove the A/C compressor discharge fitting nut and remove the compressor-to-condenser discharge line.
- Discard the gasket seal.
- To install, tighten to 15 Nm (133 lb-in).
To install, reverse the removal procedure.
- Install a new O-ring seal and new gasket seals.
- Add the correct amount of clean electric A/C compressor oil to the refrigerant system. For additional information, refer to REFRIGERANT OIL ADDING procedure.
NOTE: Motorcraft® Electric A/C Compressor Oil only must be used as a refrigerant system lubricant for hybrid vehicles. Addition of any oil other than Motorcraft® Electric A/C Compressor Oil to the hybrid vehicle refrigerant system will damage the electric Air Conditioning (A/C) compressor and contaminate the refrigerant system. Refer to REFRIGERANT OIL ADDING procedure.
Evacuate, leak test and charge the refrigerant system. For additional information, refer to AIR CONDITIONING (A/C) SYSTEM RECOVERY, EVACUATION AND CHARGING .