LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2350 (HVAC - Climate Control System) >> Removal And Installation >> Auxiliary Coolant Flow Pump >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the engine coolant. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
  2. Remove the 3 auxiliary coolant flow pump bolts.
    • To install, tighten to 25 Nm (18 lb-ft).
  3. Disconnect the auxiliary coolant flow pump electrical connector.
  4. Release the 2 heater hose clamps and disconnect the 2 heater hoses from the auxiliary coolant flow pump.
  5. Remove the auxiliary coolant flow pump.
  6. To install, reverse the removal procedure.
  7. Fill the engine coolant level. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
scientia non olet · About LEMON Manuals