LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2347 (Information System And Entertainment System) >> Removal And Installation >> Antenna Cable - AM/FM >> Installation

Antenna Cable - AM/FM: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Both cables 

  1. Overlay the new AM/FM antenna cable on the vehicle wiring harness, following the routing of the original cable.
  2. Secure the new AM/FM antenna cable with tape or zip ties, as necessary.
  3. Connect the front-to-rear AM/FM antenna cable connection at the RH kick panel.

    Front cable 

  4. Connect the front AM/FM antenna cable to the ACM  .
  5. Install the ACM  . For additional information, refer to AUDIO CONTROL MODULE (ACM) - FUSION, MILAN  or AUDIO CONTROL MODULE (ACM) - MKZ .

    Rear cable 

  6. Install the enable circuit.
    1. Insert the enable circuit CME44 (BU) into C237-25.
    2. Install the pin retainer into the inside of the male side of the connector.
    3. Connect C237.
  7. Connect the rear AM/FM antenna cable to the AM/FM antenna (Fusion, Milan) or the antenna module (MKZ).
    • For Fusion/Milan, tighten the bolt to 8 Nm (71 lb-in).
    8. NOTE: For MKZ, only the RH C-pillar trim panel was removed.
  8. Install the LH and RH assist handles, and the LH and RH C-pillar trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  9. Install the RH front and RH rear sill panels.
scientia non olet · About LEMON Manuals