Removal and Installation

All vehicles 

1. Remove the front fender splash shield. For additional information, refer to Removal and Installation .
2. Remove the fender baffle.
   Fig 1: Locating Fender Baffle

   Courtesy of FORD MOTOR CO.
3. Remove the upper rear inner fender bolt.
   • To install, tighten to 5 Nm (44 lb-in).
4. Remove the 2 lower fender bolts.
   • To install, tighten to 9 Nm (80 lb-in).

   Fusion and Milan only 

5. Remove the side turn signal lamp. For additional information, refer to EXTERIOR LIGHTING .

   All vehicles 

   NOTE: The front door must be open to gain access to the rear fender bolt.
6. Remove the upper rear fender bolt.
   • To install, tighten to 9 Nm (80 lb-in).
   Fig 2: Locating Upper Rear Fender Bolt

   Courtesy of FORD MOTOR CO.
7. Remove the bumper cover bracket from the front fender.
   1. Remove the screw.
   2. Remove the bolt.
   3. Pull outward to release the clip.
   Fig 3: Locating Bumper Cover Bracket

   Courtesy of FORD MOTOR CO.
8. Remove the fender support brace bolt.
   NOTE: Two bolts are required for Fusion and Milan, one bolt is required for MKZ.
   • To install, tighten to 9 Nm (80 lb-in).
   Fig 4: Locating Fender Support Brace Bolt

   Courtesy of FORD MOTOR CO.
9. Remove the pushpin from the front fender to headlamp.
10. Remove the upper rear inner fender bolt.
    • To install, tighten to 5 Nm (44 lb-in).
    Fig 5: Locating Upper Rear Inner Fender Bolt

    Courtesy of FORD MOTOR CO.
11. Remove the 3 upper fender bolts and the front fender.
    • To install, tighten to 9 Nm (80 lb-in).
12. To install, reverse the removal procedure.