LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2340 (Instrument Panel And Console) >> Removal And Installation >> Storage Compartment - Upper >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upper storage compartment tether nut.
    • To install, tighten to 6 Nm (53 lb-in).
    NOTE: Steering column shroud removed to show clarity.
    Fig 1: Locating Upper Storage Compartment Tether Nut
    G06271536Courtesy of FORD MOTOR CO.
  2. Remove the upper storage compartment mat and the 2 upper storage compartment screws.
  3. Remove the upper storage compartment in the following sequence.
    1. Pull the upper storage compartment toward the rear of the vehicle to release the 5 retaining clips.
    2. Disconnect the electrical connector, if equipped.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals