LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2339 (Anti-Lock Brake System - Vehicle Dynamic Systems) >> Removal And Installation >> Wheel Speed Sensor - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the fender splash shield. For additional information, refer to REMOVAL AND INSTALLATION .
  3. Disconnect the wheel speed sensor electrical connector.
  4. Remove the wheel speed sensor harness bracket-to-body bolt.
    • To install, tighten to 7 Nm (62 lb-in).
  5. Detach the wheel speed sensor harness from the wheel knuckle bracket.
  6. Remove the wheel speed sensor bolt and the wheel speed sensor.
    • To install, tighten to 23 Nm (17 lb-ft).
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals