Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Electronic modules are sensitive to electrical charges. The Anti-lock Brake System (ABS) module can be damaged if exposed to these charges.

NOTE: Do not allow any brake fluid or foreign material to enter the mating side of the Anti-lock Brake System (ABS) module or damage to the solenoids can occur.

Remove the Hydraulic Control Unit (HCU). For additional information, refer to Removal and Installation .
Remove the 4 ABS module screws and the ABS module.
- To install, tighten to 2 Nm (18 lb-in) using a cross-type pattern.
NOTE: Make sure the HCU and ABS module are clean and free of any brake fluid or foreign material before separating the components.
To install, reverse the removal procedure.
NOTE: Visually inspect the ABS module terminals for damage before installation.