Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.
WARNING:
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTE:
Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
All vehicles
- Using a suitable suction device, remove the brake fluid from the remote reservoir.
- Disconnect the brake fluid level switch electrical connector.
2.5 Hybrid, 3.0L and 3.5L vehicles
- Remove the lower cowl panel grille. For additional information, refer to COWL PANEL GRILLE .
- Disconnect the hose from the remote reservoir.
- Disconnect the brake fluid level switch harness from the brake fluid reservoir.
Courtesy of FORD MOTOR CO.
All vehicles
- Remove the brake fluid reservoir pin bolt and the brake fluid reservoir.
- To install, tighten to 6 Nm (53 lb-in).
- Remove and discard the 2 brake fluid reservoir seals.
- To install, reverse the removal procedure.
- Bleed the brake system. For additional information, refer to BRAKE SYSTEM BLEEDING .
- If equipped with a manual transmission, bleed the clutch master cylinder. For additional information, refer to CLUTCH SYSTEM BLEEDING .
NOTE: Install new brake fluid reservoir seals. Lubricate the seals with clean, specified brake fluid.