LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2332 (Rear Drive Axle/Differential) >> In-Vehicle Repair >> Stub Shaft Seal >> Installation

Stub Shaft Seal: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the Front Axle Oil Seal Installer and Adapter Handle, install the stub shaft pilot bearing housing seal.
    NOTE: Lubricate the new stub shaft seal with grease.
    Fig 1: Identifying Front Axle Oil Seal Installer And Adapter Handle
    G06065012Courtesy of FORD MOTOR CO.
  2. Install the halfshaft assembly. For additional information, refer to INSTALLATION .
scientia non olet · About LEMON Manuals