LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2328 (Information Center - Instrumentation, Message Center And Warning Chimes) >> Removal And Installation >> Instrument Panel Cluster (IPC) >> Removal

Instrument Panel Cluster (IPC): Removal

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If installing a new Instrument Panel Cluster (IPC), all vehicle keys are erased during the parameter reset procedure. Verify at least 2 of the vehicle keys are available prior to carrying out this procedure.
  1. If installing a new IPC  , upload the module configuration to the scan tool. For additional information, refer to MODULE CONFIGURATION , Programmable Module Installation (PMI).
  2. Remove the IPC  finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
  3. Remove the 3 screws and the IPC  .
    • Disconnect the electrical connector.
scientia non olet · About LEMON Manuals