Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Make sure the headlamp switch and the ignition switch are in the OFF position.
- Remove the front bumper cover. For additional information, refer to REMOVAL AND INSTALLATION .
- Remove the headlamp assembly pin-type retainer.
- Remove the 4 bolts and the headlamp assembly.
- Disconnect the electrical connectors.
- To install, reverse the removal procedure.