Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Make sure the headlamp switch and the ignition switch are in the OFF position.
All vehicles
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING
.
Fusion/Milan
- Remove the 2 outer screws and the 4 front screws from the lower radiator air deflector.
- Remove the 4 pin-type retainers and the lower radiator air deflector.
Fusion/MKZ
- Release the 4 tabs and remove the fog lamp bezel.NOTE: For MKZ, the fog lamp bezel tabs are located along the upper and lower edge close to each corner. They are released from the front using a thin flat-bladed tool (such as a pocket screwdriver). Use care not to damage the painted surface when releasing the tabs.
Milan
- Remove the 2 lower grille opening panel screws.
- Release the tabs and remove the lower grille opening panel.NOTE: The many tabs of the lower grille opening panel may be difficult to identify. They are accessed from behind the front bumper cover with the lower radiator air deflector removed.
All vehicles
- Release the locking tabs and remove the fog lamp.
- Disconnect the electrical connector.
- To install, reverse the removal procedure.