LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2318 (Rear Suspension System) >> Removal And Installation >> Wheel Studs >> Installation

Wheel Studs: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the new wheel stud in the wheel hub, aligning the serrations in the wheel hub flange made by the original wheel stud.
  2. Using a press, install the new wheel stud.
  3. Install the wheel bearing and wheel hub. For additional information, refer to Installation .
scientia non olet · About LEMON Manuals