General Specifications Table

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

GENERAL SPECIFICATIONS TABLE

Item

Specification

A/C Compressor Oil

NOTE: Use of any Air Conditioning (A/C) compressor oil other than what is specified for the specific vehicle configuration will damage the A/C compressor and contaminate the refrigerant system. For non-hybrid vehicles with a pulley driven (conventional) A/C compressor, PAG Refrigerant Compressor Oil only must be used. For hybrid vehicles with an electric A/C compressor, Motorcraft® Electric A/C Compressor Oil must be used.

A/C Pressure Relief Valve ⁽¹⁾

Close pressure

3,103 kPa (450 psi)

Open pressure

3,792-4,137 kPa (550-600 psi)

⁽¹⁾	Manifold gauge set pressures may vary slightly depending on the distance between the service gauge port valve and the A/C pressure relief valve, the A/C cycling switch or the pressure cutoff switch location.

NOTE: The specifications apply to hybrid vehicles only. For non-hybrid specifications, refer to CLIMATE CONTROL SYSTEM .