LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2313 (Accessory Drive System - 3.0L) >> Removal And Installation >> Coolant Pump Belt >> Installation

Coolant Pump Belt: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the coolant pump belt on the coolant pump pulley and position it on the camshaft pulley.
    Fig 1: Locating Coolant Pump Belt
    G06095898Courtesy of FORD MOTOR CO.
  2. Rotate the crankshaft clockwise to seat the coolant pump belt on the camshaft pulley.
    NOTE: Do not use any screwdrivers, pliers or other metal objects that could cause damage to the belt or camshaft pulley while installing the belt.
  3. Install the RH splash shield and the 6 pin-type retainers.
    Fig 2: Locating RH Splash Shield & Pin-Type Retainers
    G06272553Courtesy of FORD MOTOR CO.
  4. Position the RH fender splash shield and install the 4 screws.
    Fig 3: Locating RH Fender Splash Shield & Screws
    G06257214Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals