LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2310 (HVAC - Climate Control System - General Information And Diagnostics (Except Hybrid)) >> General Procedures >> Air Conditioning (A/C) System Recovery, Evacuation and Charging >> Refrigerant Oil Adding >> Adding Refrigerant Oil After A/C Compressor Replacement - Non-Hybrid

Adding Refrigerant Oil After A/C Compressor Replacement - Non-Hybrid

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Service A/C compressors are shipped without refrigerant oil.
  1. Rotate the old A/C compressor shaft 8 to 10 full rotations (clockwise) while collecting the PAG oil in a clean measuring cup.
    • Add the same amount plus the amount collected during refrigerant recovery.
scientia non olet · About LEMON Manuals