LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2309 (Charging System) >> Removal And Installation >> Generator - 3.0L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the A/C compressor. For additional information, refer to REMOVAL AND INSTALLATION (2.5L), REMOVAL AND INSTALLATION (3.0L/3.5L) and REMOVAL AND INSTALLATION (Hybrid) .
  2. Disconnect the battery. For additional information, refer to BATTERY DISCONNECT .
  3. Position the generator protective cover aside, remove the nut and position the generator B+ terminal aside.
    • To install, tighten to 12 Nm (106 lb-in).
  4. Disconnect the generator electrical connector.
  5. Remove the 3 bolts and the generator.
    • To install, tighten to 47 Nm (35 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals