Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove and discard the 2 exhaust Y-pipe-to-resonator nuts.
- Discard the gasket.
- To install, tighten to 40 Nm (30 lb-ft).
- Loosen Torca® clamp nut.
- To install, tighten to 47 Nm (35 lb-ft).
- Separate the resonator from the muffler and tail pipe and remove the resonator.
- To install, reverse the removal procedure.
- Install a new gasket and nuts.
- Start the engine and check for exhaust leaks.