Valve and Seat Refacing Measurements
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Refer to SPECIFICATIONS
(2.5L), SPECIFICATIONS
(Hybrid), SPECIFICATIONS
(3.0L) and SPECIFICATIONS
(3.5L)
.
NOTE:
After grinding valves or valve seats, check valve clearance.
- Check the valve head and seat.
- Check valve angles.
- Check margin width.
- Be sure margin width is within specification.
- Inspect for abnormalities on the valve face and seat. Install a new cylinder head assembly if abnormalities are found.