Cylinder Bore Taper
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Refer to SPECIFICATIONS
(2.5L), SPECIFICATIONS
(Hybrid), SPECIFICATIONS
(3.0L) and SPECIFICATIONS
(3.5L)
for the specification.
- Measure the cylinder bore at the top, middle and bottom of piston ring travel in 2 directions as indicated. Verify the cylinder bore is within the wear limit. The difference indicates the cylinder bore taper. Bore the cylinder to the next oversize limit.