Toe Adjustment - Rear

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Using alignment equipment and the manufacturer's instructions, measure the rear toe.
Loosen the toe link jam nuts.

Fig 1: Locating Toe Link Jam Nuts
Courtesy of FORD MOTOR CO.
Rotate the toe link adjusting rod until the toe setting is within specifications.

Fig 2: Locating Toe Link Adjusting Rod
Courtesy of FORD MOTOR CO.
Tighten the toe link jam nuts to 102 Nm (75 lb-ft).
NOTE: Do not allow the adjusting rod to rotate while tightening the jam nuts.
Recheck the rear toe and adjust as necessary.