LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2303 (Driveline System - General Information) >> Diagnosis And Testing >> Driveline System >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical damage.
    VISUAL INSPECTION TABLE

    Mechanical
    • U-joints
    • CV joints
    • Center bearings
    • Driveshaft tubes
    • Mounting brackets
    • Flanges
    • Housing and cover damage
    • Differential bearings
    • Differential gearsets
    • Pinion bearings
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. If the cause is not visually evident, verify the symptom and GO to SYMPTOM TABLE - NVH .