96,000 km (60,000 mi)
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- Change engine oil and install a new oil filter.
- Perform multi-point inspection (recommended).
- Rotate tires, inspect tires for wear, measure tread depth and inspect wheel ends for end play and noise. Vehicles with dual rear wheels should only be rotated if unusual wear is noted. For vehicles with different front-to-rear tire pressures, the tire pressure must be adjusted and the tire pressure sensor training must be done.
- Install a new cabin air filter (if equipped).
- Install a new engine air filter (except Focus with the PZEV engine).
- Install new climate controlled seat cushion filters (if equipped).
- Install a new fuel filter on Crown Victoria, Grand Marquis, Town Car and Mustang (not required for Fusion, Milan, MKZ, Edge, MKX, Taurus, Focus, E-Series, Expedition and Navigator with short wheelbase, F-150, Flex, MKS, Escape, Mariner, F-Series [non-Super Duty] and Transit Connect).
- Inspect automatic transmission fluid level (if equipped with an underhood fluid level indicator).
- Change automatic transmission fluid and filter on all vehicles equipped with the TorqShift® transmission.
- Inspect and lubricate control arms, steering linkage, steering ball joints, U-joints and driveshaft with zerk fittings (if equipped).
- Inspect halfshaft boots (if equipped).
- Inspect and lubricate 4WD front axle shaft U-joints (if equipped).
- Replace wheel bearing grease and install new grease seals on RWD front wheel bearings (if non-sealed bearings).
- Inspect brake pads, rotors, brake linings, drums, hoses and parking brake system.
- Inspect engine cooling system and hoses.
- Inspect exhaust system and heat shields.
- Check the rear spring U-bolt nuts for correct torque every 24,000 km (15,000 mi) (Transit Connect).