LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2299 (Manual Transaxle And Clutch - General Information) >> General Procedures >> Flywheel Runout Check >> Special Tool(s)

Special Tool(s)

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL SPECIFICATION TABLE

G06098153Courtesy of FORD MOTOR CO.
 Dial Indicator Gauge with Holding Fixture 100-D002 (D78P-4201-B) or equivalent
  1. Mount the Dial Indicator Gauge with Holding Fixture so that the Dial Indicator Gauge contact point rides on the clutch disc contact surface.
    Fig 1: Checking Clutch Disc Contact Surface Runout
    G06275819Courtesy of FORD MOTOR CO.
  2. Rotate the flywheel and check the runout.
    • If the runout exceeds the maximum runout 0.076 mm (0.0034 in), install a new flywheel.
    Fig 2: Checking Flywheel Runout
    G06275820Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals