LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2297 (Automatic Transaxle - 6F35) >> In-Vehicle Repair >> Turbine Shaft Speed (TSS) Sensor >> Removal

Turbine Shaft Speed (TSS) Sensor: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the 6 pin-type retainers and the LH front structure-to-subframe splash shield.
    Fig 1: Locating Pin-Type Retainers And LH Front Structure-To-Subframe Splash Shield
    G06278532Courtesy of FORD MOTOR CO.
  3. Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector.
    Fig 2: Locating Turbine Shaft Speed (TSS) Sensor Electrical Connector
    G06278533Courtesy of FORD MOTOR CO.
  4. Remove the bolt and the TSS  sensor.
Fig 3: Locating Bolt And TSS Sensor
G06278534Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals