LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2297 (Automatic Transaxle - 6F35) >> In-Vehicle Repair >> Halfshaft Seal - RH, All Wheel Drive (AWD) >> Installation

Halfshaft Seal - RH, All Wheel Drive (AWD): Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new halfshaft seal on the RH Halfshaft Fluid Seal Installer.
    Fig 1: Locating RH Halfshaft Fluid Seal Installer
    G06278543Courtesy of FORD MOTOR CO.
  2. Using the RH Halfshaft Fluid Seal Installer, install the RH halfshaft seal.
    Fig 2: Installing RH Halfshaft Seal
    G06278544Courtesy of FORD MOTOR CO.
  3. Install the PTU  . For additional information, refer to POWER TRANSFER UNIT (PTU) .
  4. Fill the transaxle with clean transmission fluid.
    Fig 3: Locating Transmission Fluid Level Indicator
    G06278545Courtesy of FORD MOTOR CO.
  5. Start the engine and let it run for 3 minutes. Move the range selector lever into each gear position. Check the transmission fluid level, making sure that the transmission fluid is at the correct level.
scientia non olet · About LEMON Manuals