Leak Check Test With UV Lamp
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
Dye-Lite® ATF Steering Fluid Leak Detection Dye 164-R3701 or equivalent (specifically formulated for ATF ) is used to detect a transmission fluid leak.
- Add dye to the transmission fluid. Use 30.0 ml (1 oz) of dye solution for every 3.8L (4 qt) of transmission fluid.
- Start and run the engine until the transaxle reaches its normal operating temperature. Using the 100W/12 Volt UV Lamp, observe the back of the cylinder block and top of the torque converter housing for evidence of fluid leakage. Raise the vehicle on a hoist and run the engine at fast idle, then at engine idle, occasionally shifting to the DRIVE and REVERSE ranges to increase pressure within the transaxle. Observe the front of the flexplate, back of the cylinder block (in as far as possible), and inside the torque converter housing and front of the case. Continue running the engine until fluid leakage is evident and the probable source of leakage can be determined.