LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2295 (Engine Mechanical - 2.5L (Hybrid)) >> Disassembly And Assembly Of Subassemblies >> Cylinder Head >> Assembly

Cylinder Head: Assembly

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the valves.
    NOTE: Coat the valve stems with clean engine oil.
  2. Using the Valve Stem Oil Seal Installer, install the valve seals.
    NOTE: Use the protector provided with the replacement kit to prevent damage to the valve seals. Lubricate the valve stems and guides with clean engine oil.
    Fig 1: Identifying Valve Seal
    G06094983Courtesy of FORD MOTOR CO.
  3. Using the Valve Spring Compressors, install the valve springs.
    • Insert the valve springs and the valve spring retainers.
    • Compress the valve springs and install the valve collets, using grease and a small screwdriver.
    NOTE: Check the seating of the valve collets.
    Fig 2: Identifying Valve Spring & Retainer Special Tools
    G06094972Courtesy of FORD MOTOR CO.
  4. Install the valve tappets.
    NOTE: Coat the valve tappets with clean engine oil.
  5. Install the spark plugs.
    • Tighten to 12 Nm (106 lb-in).
    NOTE: Only use hand tools when removing or installing the spark plugs or damage can occur to the cylinder head or spark plugs.
  6. Install the CHT  sensor.
    • Tighten to 12 Nm (106 lb-in).
  7. Using a new gasket, install the coolant outlet and bolts.
    • Tighten to 10 Nm (89 lb-in).
  8. Install the EGR valve, using a new gasket.
    • Tighten to 20 Nm (177 lb-in).
scientia non olet · About LEMON Manuals