LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2294 (Engine Mechanical - 3.5L) >> In-Vehicle Repair >> Crankshaft Pulley >> Removal

Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2010 Lincoln MKZ and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the accessory drive belt and the power steering belt. For additional information, refer to REMOVAL .
  3. Using the Strap Wrench, remove the crankshaft pulley bolt and washer.
    • Discard the bolt.
    Fig 1: Locating Crankshaft Pulley Bolt & Washer
    G06061937Courtesy of FORD MOTOR CO.
  4. Using the 3 Jaw Puller, remove the crankshaft pulley.
    Fig 2: Identifying Jaw Puller
    G06061968Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals