LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2294 (Engine Mechanical - 3.5L) >> In-Vehicle Repair >> Crankshaft Pulley >> Installation

Crankshaft Pulley: Installation

WARNING: This page is about a different car, the 2010 Lincoln MKZ and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the crankshaft front seal inner lip with clean engine oil.
  2. Using the Front Cover Oil Seal Installer and Crankshaft Vibration Damper Installer, install the crankshaft pulley.
    NOTE: Lubricate the outside diameter sealing surfaces with clean engine oil.
    Fig 1: Installing Crankshaft Pulley Using Crankshaft Vibration Damper Installer
    G06062623Courtesy of FORD MOTOR CO.
  3. Using the Strap Wrench, install the crankshaft pulley washer and new bolt and tighten in 4 stages.
    • Stage 1: Tighten to 120 Nm (89 lb-ft).
    • Stage 2: Loosen one full turn.
    • Stage 3: Tighten to 50 Nm (37 lb-ft).
    • Stage 4: Tighten an additional 90 degrees.
    Fig 2: Locating Crankshaft Pulley Washer And Bolt
    G06269784Courtesy of FORD MOTOR CO.
  4. Install the accessory drive belt and the power steering belt. For additional information, refer to INSTALLATION .
scientia non olet · About LEMON Manuals