Cylinder Head: Disassembly

WARNING: This page is about a different car, the 2010 Lincoln MKZ and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

All cylinder heads

NOTE: If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into their original locations.

Using the Valve Spring Compressors, remove the keys, retainer and spring.

Fig 1: Identifying Valve Springs Compressors
Courtesy of FORD MOTOR CO.
Remove the valve from the cylinder head.
Remove and discard the valve stem seal.
Repeat the above steps for each valve.
RH cylinder head
Remove and discard the Cylinder Head Temperature (CHT) sensor.

Fig 2: Locating Cylinder Head Temperature Sensor
Courtesy of FORD MOTOR CO.