LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2294 (Engine Mechanical - 3.5L) >> Disassembly And Assembly Of Subassemblies >> Cylinder Head >> Assembly

Cylinder Head: Assembly

WARNING: This page is about a different car, the 2010 Lincoln MKZ and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

All cylinder heads 

  1. Using the Valve Stem Oil Seal Installer, install a new valve stem seal.
    NOTE: Lubricate the valve stem seal with clean engine oil prior to installation.
    Fig 1: Identifying Valve Stem Oil Seal Installer
    G06062541Courtesy of FORD MOTOR CO.
  2. Install the valve.
  3. Using the Valve Spring Compressors, install the valve spring, retainer and key.
    Fig 2: Identifying Valve Spring Compressors
    G06270316Courtesy of FORD MOTOR CO.
  4. Repeat the above steps for each valve.

    RH cylinder head 

  5. Install a new CHT  sensor.
    • Tighten to 10 Nm (89 lb-in).
scientia non olet · About LEMON Manuals