LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2293 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Oil Pump Screen and Pickup Tube >> Removal

Oil Pump Screen and Pickup Tube: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material (including any material created while cleaning gasket surfaces) that enters the oil passages, coolant passages or the oil pan, may cause engine failure.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the oil pan. For additional information, refer to ENGINE LUBRICATION COMPONENTS - EXPLODED VIEW  and Removal .
  3. Remove the bolts the oil pump screen and pickup tube.
    • Remove and discard the O-ring seal.
    Fig 1: Locating Oil Pump Screen & Pickup Tube With Bolts
    G06263441Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals