LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2293 (Engine Mechanical - 3.0L (4V)) >> In-Vehicle Repair >> Crankshaft Rear Seal >> Removal

Crankshaft Rear Seal: Removal

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the flexplate. For additional information, refer to Removal and Installation .
  3. Using the Slide Hammer and the Crankshaft Rear Oil Seal Remover, remove and discard the crankshaft rear oil seal.
    Fig 1: Removing Crankshaft Rear Oil Seal
    G06263341Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals