LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2292 (Engine Mechanical - 2.5L (Except Hybrid)) >> In-Vehicle Repair >> Valve Springs >> Installation

Valve Springs: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the Valve Spring Compressors, install the valve spring.
    • Insert the valve spring and the valve spring retainer.
    • Compress the valve spring and install the valve collet using some grease and a small screwdriver.
    NOTE: Check the seating of the valve collet.
    Fig 1: Identifying Valve Spring & Valve Spring Retainer Special Tools
    G06261916Courtesy of FORD MOTOR CO.
  2. Disconnect the compressed air supply.
  3. Repeat the appropriate removal and installation steps for all of the other cylinders.
  4. Install the spark plugs. For additional information, refer to REMOVAL AND INSTALLATION .
  5. Coat the valve tappets with clean engine oil and insert them.
  6. Install the camshafts. For additional information, refer to Installation .
scientia non olet · About LEMON Manuals