DTC P1100: Mass Air Flow (MAF) Sensor Circuit Intermittent
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2010 Mercury Mountaineer, 2010 Mercury Milan, 2010 Mercury Mariner, 2010 Mercury Grand Marquis, and 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
DTC P1100: MASS AIR FLOW (MAF) SENSOR CIRCUIT INTERMITTENT
| Description: | The MAF sensor circuit is monitored by the powertrain control module (PCM) for sudden voltage (or air flow) input change through the comprehensive component monitor (CCM). If during the last 40 warm-up cycles in ignition on, engine running the PCM detects a voltage (or air flow) change beyond the minimum or maximum calibrated limit, a continuous memory DTC is stored. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | While accessing the MAF PID on the scan tool, lightly tap on the MAF sensor or wiggle the MAF sensor connector and harness. If the MAF PID suddenly changes below 0.23 volt or above 4.60 volts, an intermittent fault is indicated. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST DC . | ||